single interrupted suture and slipknot
material
- 3d printer (recommended filament printer)
- 3d print material (PLA/PET)
- plastic- or superglue
- glueable hook and loop fastener or magnets, depending on pelvi system
- silicone hardness shore 00-30
- silicone color
- mixing container and mixing sticks
- tights 20DEN fair (optional)
- for the new version: 4 times 10mm x1mm nails
If you have no 3d printer, you can use any box with:
L= 11cm W=4cm H>2cm
STL files
new version:
instruction
- print the STL files in original size
- cut the tights to 10cm x 3cm(optional)
- first layer silicone 20ml ( if 1A:1B each Part 10ml)
- mix silicone and color as specified by the manufacturer with white and red color
- cast silicone into the mold and wait to cure
- put the thights smooth at the layer (optional)
- second layer of silicone 40ml (if 1A:1B each Part 20ml)
- mix silicone and color as specified by the manufacturer with "bowely" color
- cast silicone into the mold and wait to cure
task preperation:
- chuck the pad between to clamps:
- for "single interrupted suture" put the small blocker under the pad.
- for "slipknot" put the bigger blocker under the pad
new version:
- put the pad in the holder and fix it with the nails
